Current position > Product detail
『Installation of turbine flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. Correct installation of turbine flowmeter instrument
The correct installation method of turbine flowmeter instrument is as follows: power line selection and grounding: The power line of the transmitter should use metal shielded wire and ensure good and reliable grounding. The power supply should be 24V DC with an impedance of 650 Ω. This step is crucial for ensuring the stable operation of the turbine flowmeter and can effectively prevent electromagnetic interference. Installation position and direction: Horizontal installation: The transmitter should be installed horizontally to avoid vertical installation. Horizontal installation can ensure the normal rotation of the turbine inside the flowmeter, thereby accurately measuring fluid flow. Requirement for straight pipe section: During installation, sufficient straight pipe sections should be ensured before and after the flowmeter to reduce the impact of fluid flow instability on measurement results. Consistent flow direction: Ensure that the flow direction of the fluid is consistent with the direction of the arrow on the instrument housing, and do not install it in reverse. This is the basic condition for ensuring accurate measurement of flow meters. Medium requirements: The tested medium must not corrode the turbine, especially at the bearings. If the medium is corrosive, corresponding anti-corrosion measures should be taken, such as using corrosion-resistant materials or installing anti-corrosion coatings, to protect the turbine flowmeter from damage. Magnetic induction protection: During installation, special attention should be paid to the protection of the magnetic induction part to avoid collisions. The magnetic induction part is a key component of the
2. Can the turbine flowmeter be installed vertically?
The turbine flowmeter can be installed vertically.. When installing a turbine flowmeter, the following points should be noted: fluid direction: When installed vertically, the fluid direction must be upward. This is to ensure that the flowmeter can accurately measure the flow rate of the fluid. Stay away from interference: Keep away from external electric and magnetic fields, and take effective shielding measures when necessary to avoid the influence of external interference on measurement results. Full pipe fluid: During installation, the pipeline must be filled with fluid, that is, the liquid should fill the pipeline without bubbles to ens